Advertisement
6
Start the software upgrade by using the "left or right arrow" key of the remote control to select "Yes".
7
Press "OK" key of the remote control to begin the upgrade.
8
The software upgrading process will begin. During the software upgrade, the TV receiver will display
"Updating... don't AC power off" as shown in Figure4.
During this time, do not remove power to the television or press any remote keys or buttons
on the television until the upgrade is complete!
9
Upon completion of the software upgrade a message will appear as shown in Figure5.
10
Remove the "USB Drive" from the slot.
11
The TV will turn OFF and then, turn ON automatically.
12
Perform the "Initial Setup" and set "Personal Preference" of the TV.
Refer to your Owner's manual should you have any questions.
Copyright 2010
Figure4
Figure5
All Rights Reserved
Page 2 of 2
Advertisement
