Page 2
Remove Mineral Deposits From Drinking ADJUST CONTROL VALVE ADJUST WATER LEVEL IN DRINKING BOWL Bowl - Over an extended period of time Adjusting the control valve is necessary mineral deposits can form on the stainless The level of water in the drinking bowl can when installing a new waterer, after parts are steel bowl.
Page 3
not swirl out of bowl when refilling. Note: If THERMOSTAT allow the heater assembly to be removed from water seeps from top of brass shut-off valve, the waterer. The heater assembly consists of 1. Remove thermostat from waterer (See tighten packing nut located below valve handle the heating element, heat deflector, and two Removing/Replacing Heater &...
Page 4
has come out of position, reposition shaft and C. INSPECTING/REPLACING INLINE WARNING! TURN OFF WATER FILTER & CONTROL VALVE replace the cotter key. ELECTRICITY WHEN If dripping and overflow continues and 4. Check the position of the beam lock lever SERVICING WATERER.
Page 5
If a fuse has The most efficient method used to protect your hands. DO NOT use a wrench. Nelson blown or a breaker has tripped, there may be a the riser pipe from freezing is to utilize the sells internal valve components or the entire safety issue with the circuit.
D. Vertical Water Line Makes Contact With Nelson ACC.#TC730 for Models 730 7. Over top cover install Nelson Thermal Heat Well Thermal Cap Accessory. The Nelson Thermal Cap is ACC.#TC760 for Models 760 designed to reduce energy consumption and A vertical waterline that is bowed and to keep the waterer clean when not in service.
Page 7
Waterer Components - Top Cover & Bowl Removed STRAIN RELEIF CONNECTOR LOCATION OF INLINE WATER FILTER THERMOSTAT BRASS SHUT-OFF VALVE HEATER ASSEMBLY SCREWS HEAT SHEILD (BOTTOM PART OF HANDY BOX HEATER ASSEMBLY) HEATING ELEMENT CROSS BEAM (LOCATED UNDER CROSS BEAM) WATER SPOUT TUBE WATER SUPPLY HOSE CONTROL VALVE...
Page 8
1. after winter season when temperatures are consistently above freezing. 2. when using a tool to service or maintain waterer. CONCRETE PAD NELSON WATERLINE INSULATION ACCESSORY #1004. LEAVE 2” AIR WALL-MOUNT MODEL GAP BETWEEN INSULATION AND HEATER ASSEMBLY IN WATERER.
Page 9
Installation In Freezing Climate - Plumbing Inside Waterer TOP VIEW COVER AND BOWL REMOVED WATER SUPPLY HOSE WARNING! SHUT-OFF SHOULD VALVE AND WATER SUPPLY HOSE LOCATED LOCATION OVER CROSS Failure to install the BEAM, shut-off valve and water ON SAME supply hose in the proper SIDE AS location may result in...
HEATER & THERMOSTAT INSTALLATION DIAGRAMS TOP VIEW: COVER & BOWL REMOVED WARNING! TURN OFF ELECTRICITY WHEN SERVICING WATERER Always turn off power to waterers when using a tool to service or ELECTRICAL STRAIN RELIEF CONNECTOR maintain waterer to eliminate risk of electrocution. Waterers should be on HEAT SHEILD JUNCTION BOX dedicated circuits.
Page 11
Instructions For Replacing Plumbing Parts Including Control Valve & Filter TOP VIEW: COVER & BOWL REMOVED WATER FILTER LOCATION Brass Shut-off Valve Beam Copper Tube Water Brass Shut-off Valve Lock Supply Lever Cross Beam Filter Hose • Water supply hose and shut-off valve should be located as shown in diagram on left for easier filter access and maximum freeze protection.