Epson SC-P9500 Series User Manual page 107

SC-P9500 Series/SC-P7500 Series User's Guide
Settings item
Paper Source Settings
Roll Paper Setup
Auto Loading
Cut Settings
Auto Cut
Print Cutting Guideline
Wait for Cut Between Pages
Cut for Borderless Print
Quick Cut
Cut Mode
Margin Refresh
Roll End Option
Take-up After Cut
Error Notice
Paper Size Notice
Paper Type Notice
Detect Paper Meandering
Platen Gap Offset
Custom Paper Setting
01-30
Change Name
Change Reference Paper
Menu List
Setting/Additional Explanation
On, Off
On, Off
On, Off
If Auto Cut is set to Off, you can choose whether or not (On/Off) to print
cutting lines on roll paper. Cutting lines are not printed if Auto Cut is set to
On or when printing cut sheets or poster board.
On, Off
Two Cuts, One Cut
On, Off
Normal, Quiet
On, Off
Before printing with borders, select whether or not (On/Off) to
automatically cut the leading edge to remove ink stains that may have
been left by previous borderless printing.
Continue, Stop Printing, Reprint
Select the action to perform for a roll after replacement: print the
remaining data (Continue) / do not print (Stop Printing) / print again from
the beginning (Reprint).
Reprint is only available when the optional hard disk unit is installed.
On, Off
This item is only displayed when the take-up reel unit is connected.
"Removing Paper from the Auto Take-up Reel Unit" on page 41
U
On, Off
On, Off
On, Off
Standard, Wide, Wider, Widest
Display Registered Number & Registered Media Name
From the printer, you cannot change paper setting information registered
using the driver or other software.
Displays the media name registration screen
Displays the reference paper type
107