Trip Meter Reset - Triumph Speed Triple S Owner's Handbook Manual

Each display provides the following
information all calculated since the trip
meter was last reset to zero:
Trip Time
The total time elapsed.
Average Fuel Consumption
An indication of the average fuel
consumption. After being reset the
display will show dashes
0.1 miles/km has been covered.
Instantaneous Fuel Consumption
An indication of the fuel consumption at
an instant in time.
Average Speed
The average speed is calculated from
when the trip computer was last reset.
After being reset the display will show
dashes until 1 mile/km has been covered.
Odometer
The odometer shows the total distance
that the motorcycle has traveled.
Lap Timer
The lap timer shows the lap time,
number of laps, average
maximum speed and distance traveled,
depending if in recording or reviewing
mode.
Trip Distance
The total trip distance traveled.
Range to Empty
This is an indication of the probable
distance that can be traveled on the
remaining fuel in the tank.
General Information
Do not attempt to switch between
odometer and trip meter display
modes or reset the trip meter with the
motorcycle in motion as this may lead
to loss of motorcycle control and an
accident.

Trip Meter Reset

until
To reset the trip meter, select and
display the trip meter then press the
SCROLL button for one second. After
one second, the trip meter will reset to
zero.
Note:
• When the trip meter is reset to zero,
the trip
consumption and average speed will
also be set to zero for the trip meter.
To exit the trip meter, press and release
the SCROLL button until the desired
display is shown.
speed,
Warning
time, average fuel
29