E L E C T R O N I C G E A R B O X S Y S T E M
-
Gear
controls
under
steering wheel
Place the gear lever in position M,
and then the controls under the
steering wheel will give you access
To change gear:
•
Pull the control "+" towards you
to engage a higher gear.
•
Pull the control "-" towards you
to change down.
These controls do not permit you to
select neutral or reverse gear, nor
do they enable you to quit reverse
gear.
M A N U A L M O D E
+
the
Commands using the gear
lever
Place the gear lever in position M,
then:
•
Push the lever to change to a
higher gear.
•
Pull the lever to change down.
Remarks:
•
When
the
speed, for example approach-
the
gearbox
automatically to 1st gear.
•
In manual mode, it is not neces-
sary to release the accelerator
during changes of gear.
•
•
Re-initialisation
The Electronic Gearbox System
requires a re-initialisation after one
of the following events:
•
•
•
To re-initialise the system:
•
•
vehicle
reduces
•
changes
down
•
Starting is again possible.
A command to change gear
is accepted only if the engine
speed permits this.
As the engine reaches maxi-
mum revs and conditions per-
mit, the system will automati-
cally engage a higher gear.
Change of battery or discon-
nection of battery.
Starting the engine with an
assisting battery.
A system malfunction.
Switch on the ignition. A dash
and "AUTO" will display in the
instrument panel.
Apply the brake pedal.
Wait until you see N, or a gear
engaged,
in
the
instrument
Release the brake.
II