MB QUART Polaris 4017291 Operation & Pairing

Congratulations on your choice of a Polaris Bluetooth
controller by MB Quart. This is a simple operation and
pairing manual. For more detailed information, visit our
website at MBQuart.com and go to the TEQ support
section or the Frequently asked questions.
CAUTION
Always consider consulting a professional audio installer
before installing any audio components. Be careful and take
your time. Do not let wires make contact with metal edges or
hot engine components.
Switch Mounting
MOUNTING
The controller is designed to mount in a standard rocker switch
opening for accessories. Do not attempt to remove the unit from the
switch housing. The housing is an integral part of the unit.
The unit itself requires a 0.83 inch (21mm) wide by 1.4 inch (37mm)
high opening with at least 2.5 inches of clearance behind the
mounting surface. Before drilling any holes make sure there are no
obstructions behind the mounting surface.
Keep enough space around the controller, if possible, to
accommodate the operator's fingers.
RUBBER GASKET
Make sure the included rubber gasket
remains in place during installation. This
gasket aides in keeping the unit water
resistant.
AUX INPUT – 3.5MM JACK
The 3.5mm input jack is located on the
bottom of the unit. Remember to re-insert
the water resistant rubber plug when not
using the input. The control unit should
always be mounted with the 3.5mm jack on
the bottom.
Multi-Function Joystick Operation
®
The multi-function joystick has multiple operations for various
features. Take a minute to familiarize yourself with all of the functions
to better and more quickly navigate your new Bluetooth controller.
VOLUME
Slowly turn the controller clockwise to increase volume and counter
clockwise to decrease volume. Turning the dial quickly does not
increase the speed of volume increase or decrease. Under AUX
mode the volume will be controlled by your device.
POWER ON/OFF
3.5MM SIGNAL INPUT
BLUETOOTH CONTROL
Rubber Gasket
3.5mm Plug
Press and hold control volume for 3 seconds to power
the unit on/off
the controller will automatically switch from Bluetooth
to the AUX input by plugging your device into the 3.5mm
input.
RIGHT/DOWN TOGGLE
Toggle right or down to advance to the next track
LEFT/UP TOGGLE
Toggle left or up to back up to previous track
Bluetooth Device Pairing
®
The pairing process can vary based on your particular device.
Refer to the operating instructions of your device. Below is the
general process to connect the controller.
The Bluetooth Controller will flash slowly when "searching" for the
®
last paired device.
If no device is located, it will flash quickly indicating it is ready to
pair to a new device. On your Bluetooth enabled device, search for
POLARIS under Bluetooth settings.
Select POLARIS; wait for the device to indicate "connected". The
status indicator will change to solid red. Music will now play through
the system.