GE Monogram Installation Instructions Manual page 10

Step 1:
Disconnect power to the ice machine.
Step 2:
Remove handle and nameplate
• Remove the door handle by removing the
• The Monogram nameplate is held in place
Step 3:
Mark mounting screw locations.
• Align and hold the side trim pieces against
• Drill 1/8" pilot holes into the door sides of
Step 4:
Secure custom handle to custom panel.
(Skip this step if you are using the supplied
handle.)
A custom handle can be installed onto the
3/4" thick panel, replacing the supplied
handle.
• The custom handle can be installed at the
• Drill pilot holes through the front of the
• Secure the handle to the panel with flat
• Replace original handle screws in the top of
Step 5:
Secure side trim pieces to custom panel.
• Lay the custom panel, appearance side down
• Align top and bottom side trim to the
• Tape the side trim pieces to the back of the
• Place the panel with trim against the door to
• Mark screw locations and remove trim. Drill
• Install side trim to the back side of the
10
two top mounting screws. Set screws aside.
Discard handle.
with adhesive. Remove the nameplate.
the ice machine door and mark screw
locations on the sides.
the ice machine.
top or side of the panel.
custom panel to match the chosen handle.
head wood screws.
the door frame.
on a clean surface.
custom panel sides.
custom panel.
be sure that trim and panel fits the door side
to side and top to bottom. Adjust as needed.
pilot holes.
custom panel with screws (not supplied).
Use flat head wood screws approximately
1/2" long.
ZIP75WW, ZIP75BB Kit
For 3/4" Custom Panel
Step 6:
Install assembled panel onto the ice machine.
• Install panel to ice machine with supplied
screws, 4 on each side.
Step 7:
Install supplied door handle (if used)
• Install the new supplied handle with original
screws.