Use The Remote Control - ZyXEL Communications STB-1001H Quick Start Manual

Zyxel set-top box quick start guide

Hide thumbs Also See for STB-1001H:

If the

1001H's connections. Make sure that the power is on and the Internet

access device is working. If this does not help, restart the STB-1001H

(switch it off, then on using the ON/OFF switch on the rear panel). If the

problem persists, contact your vendor.

3 A start-up picture displays on the television. When the STB-1001H has successfully

started up, the Home menu displays. Your STB-1001H is ready to use!

The TV pictures shown in this Quick Start Guide are examples; what you see

may be different (depending on your IPTV service provider).

3 Use the Remote Control

Before you first use the remote control, take the following steps to insert two AAA-size

batteries.

1 Press the battery cover release catch in and lift the cover off.

2 Press the batteries into the compartment. The negative (-) end of each battery should

be at the end of the slot that has a spring.

3 Replace the cover.

lights do not behave as expected, first check the STB-

ENGLISH

Table of Contents