Installation Instructions - Polaris 4500 HD Manual

INSTALLATION INSTRUCTIONS

CAUTION
BEFORE STARTING INSTALLATION, always
ensure vehicle is properly secured on a flat stable
surface to avoid accidental tipping, unwanted
movement and to prevent personal injury and/or
damage to equipment. Shift vehicle transmission into
"PARK". Turn key to "OFF" position and remove from
1. DISCONNECT BATTERY.
ALWAYS disconnect black negative (-) cable from
battery FIRST. Failure to do so will result in a high
current electrical arc, and may result in battery
explosion, if tool touches grounded frame. Death or
serious personal injury may occur.
a. Lift the driver side seat latch
seat bottom and remove the driver seat
seat aside for later reinstallation.
b. Remove battery access panel
battery terminals.
vehicle.
WARNING
A
located behind
C
to access the
Instr 9929139
c. Disconnect black negative (-) cable from
battery FIRST.
d. Next, disconnect red positive (+) cable from
battery.
2. REMOVE HOOD.
B
. Set
a. Rotate the two hood latches to release the
hood. Pull the hood forward and up to remove
from vehicle.
3. REMOVE WINCH COVER.
a. Remove lower front winch cover
removing four push rivets
Rev 01 2018-08 Page 3 of 13
A
by
B
.