Table of Contents
Advertisement
Quick Links
848-AE0-93A2 (706)
OWNER / OPERATOR MANUAL
PORTABLE GAS DRILL
EDG2300
(NOTE: Drill is optional part.)
Thank you for purchasing a RedMax
WARNING
product.
The engine exhaust from this product
Before using our portable gas drill,
contains chemicals known to the State
please read this manual carefully to
of California to cause cancer, birth
understand the proper use of your unit.
defects or other reproductive harm.
APPLICABLE SERIAL NUMBERS :
901112 and up
Advertisement
Table of Contents
Summary of Contents for Zenoah EDG2300
- Page 1 848-AE0-93A2 (706) OWNER / OPERATOR MANUAL PORTABLE GAS DRILL EDG2300 (NOTE: Drill is optional part.) Thank you for purchasing a RedMax WARNING product. The engine exhaust from this product Before using our portable gas drill, contains chemicals known to the State...
-
Page 2: Safety First
Read this manual carefully to understand all safety precautions, controls, proper operation and maintenance of your RedMax portable gas drill. Failure to do so could result in serious injury. Instructions contained in warnings within this manual marked with a concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. -
Page 3: Table Of Contents
SAFETY PRECAUTIONS ... 4 IN ORDER TO ENSURE PROPER AND SAFE OPERATION OF YOUR PORTABLE GAS DRILL WORK GEAR AND CLOTHING WARNINGS CONSIDERING HANDLING OF FUEL THINGS TO CHECK BEFORE USING YOUR PORTABLE GAS DRILL THINGS TO CHECK BEFORE STARTING UP THE ENGINE AVOID NOISE PROBLEM THINGS TO BE CAREFUL ABOUT WHEN USING YOUR PORTABLE GAS DRILL NOTES ON CARE AND MAINTENANCE OF YOUR PORTABLE GAS DRILL... -
Page 4: Safety Precautions
Safety Precautions ■ IN ORDER TO ENSURE PROPER AND SAFE OPERATION OF YOUR PORTABLE GAS DRILL • Read this Owner/Operator Manual carefully. Be sure you understand how to operate this unit properly before you use it. Failure to do so could result in serious injury. -
Page 5: Work Gear And Clothing
Safety Precautions ■ WORK GEAR AND CLOTHING • When using your portable gas drill, always be sure to wear strong, durable, work clothing; shirts should be long-sleeved shirts and pants should be full-length pants reaching down to the ankles. • Always be sure to wear and helmet and face protector when using your portable gas drill. -
Page 6: Things To Check Before Using Your Portable Gas Drill
Safety Precautions ■ THINGS TO CHECK BEFORE USING YOUR PORTABLE GAS DRILL • Before beginning work, look around carefully to get a feel for the shape of the land, and whether or not there are any obstacles which might get in the way while working, and remove any obstacles which can be cleared away before beginning work. -
Page 7: Things To Be Careful About When Using Your Portable Gas Drill
Safety Precautions ■ THINGS TO BE CAREFUL ABOUT WHEN USING YOUR PORTABLE GAS DRILL • When using your portable gas drill, grip the handles of the portable gas drill firmly with both hands, place your feet slightly apart (slightly further apart than the width of your shoulders) so that your weight is distributed evenly across both legs, and always be sure to maintain a steady, even... -
Page 8: Notes On Care And Maintenance Of Your Portable Gas Drill
REFER TO OWNER'S MANUAL FOR MAINTE- NANCE, SPECIFICATIONS AND ADJUSTMENTS. MANUFACTURED: USE JASO FC OR ISO EGC GRADE 50:1 OIL. ZENOAH CO.,LTD. *1: The initial number will be changed every year of manufacturing. 8 • Always be sure to turn off the engine before performing any maintenance or checking procedures. -
Page 9: Parts Location & Specifications
Automatic centrifugal clutch and reduction gears in (mm) cc (cu. in) kW (HP) Mixture (Gasoline 50 : 2-cycle oil 1) (when using RedMax/ZENOAH genuine oil) pints ( ) Transistor controlled flywheel magneto Specifications are subject to change without notice. Stop switch... -
Page 10: Fuel
OIL or ISO EGC GRADE) • Do not use BIA or TCW (2-stroke water- cooling type) mixed oil. 10 ■ RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1 (when using RedMax/ZENOAH genuine oil) 50:1 MIXING CHART GASOLINE gal. 2-CYCLE OIL fl.oz 2.6... -
Page 11: Fueling The Unit
Fuel 4. Pour In the rest of gasoline and agitate again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizing due to abnormally lean mixture. -
Page 12: Operation
Operation ■ THROTTLE CABLE ADJUSTMENT Check the throttle cable play and adjust to .04 or .08 in. (1~2mm) at the carburetor side. .04 or .08 in. Adjusting screw (1~2mm) ■ STARTING ENGINE 1. When first starting up after putting fuel into the machine, or when re-starting after running out of fuel, push the priming pump until fuel runs out the overflow pipe. -
Page 13: Stopping Engine
Operation ■ STOPPING ENGINE • Release the throttle lever and press on the red button until the engine comes to a complete stop. ■ BORING OPERATION • Keep the engine running at full throttle during operation. • Keep the drill going straight. Tilted boring can cause the drill to bend. -
Page 14: Maintenance
Maintenance Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual. ■ MAINTENANCE CHART system/compornent fuel leaks, fuel spillage fuel tank, air filter, fuel filter idle adjusting screw spark plug cylinder fins, intake air cooling vent muffler, spark arrester, cylinder exhaust port... -
Page 15: Inspection Every 100 Hours
Maintenance • Check and clean the spark plug. Adjust the electrode gap to .024~.028in (0.6~0.7mm) if necessary. .024 ~ .028 in (0.6~0.7mm) Replacement plug: NGK BPMR7A ■ INSPECTION EVERY 100 HOURS • The muffler is equipped with a spark arrester to prevent red hot carbon from flying out of the exhaust outlet. -
Page 16: Storage
Storage ■ BEFORE LONG-TERM STORAGE • Drain fuel tank and run engine out until all fuel in the carburetor is used up. • Remove the spark plug and drop a spoonful 2 cycle oil into the cylinder. Crank the engine several times and replace the plug. -
Page 17: Parts List
PORTABLE GAS DRILL EDG2300 NOTE : 1. Use RedMax/ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. RedMax/ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company. - Page 18 Parts List : EDG2300 Fig.1 DRIVE UNIT and TOOLS (S/N 901112 and up) 18 ...
- Page 19 EDG2300 Fig.1 DRIVE UNIT and TOOLS Key# Part Number Description 3871-21100 Right handle comp. 3871-21120 • Grip 3871-21320 Stay 3545-14240 Bolt 01641-21423 Washer 3524-14400 Lever, Throttle 0280-10504 01601-20513 Washer 0263-30516 Screw 0280-10504 3872-21510 Bracket, Right 3871-21200 Left handle comp. 3541-14221 •...
- Page 20 Parts List : EDG2300 Fig.2 ENGINE UNIT (S/N 901112 and up) 20 ...
- Page 21 EDG2300 Fig.2 ENGINE UNIT Key# Part Number Description 5602-12110 CYLINDER 5500-12213 GASKET, base 1850-12130 BOLT M5x12 5500-13163 INSULATOR 5500-13121 GASKET, INSULATOR 5500-13131 GASKET, CARB 0263-90520 SCREW M5x20 5602-15100 MUFFLER ASSY 1601-15120 • ARRESTER 01252-30550 BOLT M5x55 5500-15210 GASKET, MUFFLER 5600-15220...
-
Page 22: Limited Warranty
AMERICA, INC. AT (770)-381-5147. IMPORTANT: YOU WILL RECEIVE A WARRANTY REGISTRATION CARD AT TIME OF PURCHASE.PLEASE FILL OUT THE CARD AND SEND IT TO RedMax / ZENOAH AMERICA WITHIN SEVEN (7) DAYS. BE SURE TO KEEP A COPY FOR YOUR RECORDS. - Page 23 Cette garantie vous donne des droits juridiques spécifiques, et vous pouvez également jouir d’autres droits variant d'une province à l'autre. Si vous désirez obtenir des informations sur le centre de service le plus proche, veuillez appeler RedMax / ZENOAH AMERICA, INC. au (770)-381-5147 Note importante: vous recevrez une carte d'enregistrement de garantie au moment de l'achat.
- Page 24 ZENOAH AMERICA, INC. 1100 Laval Blvd. Suite 110 Lawrenceville, Georgia 30043 © Printed in Japan...