Operation - Zenoah G3200 Owner's/Operator's Manual

7. Operation

F7-1
(2)
F7-2
(1)
F7-3
(1)
(1)
F7-4
(2)
F7-5
It is very dangerous to run a chainsaw that
mounts broken parts or lacks any parts.
Before starting engine, make sure that all the
parts including bar and chain are installed
properly.
(1)
■ STARTING THE ENGINE
1. Fill fuel and chain oil tanks respectively, and
tighten the caps securely.
(1) Fuel
2. Set the switch to "I" position.
(1) Switch
3. Continuously push the priming bulb until fuel
comes in the bulb.
(1) Priming bulb
4. Pull out the choke knob completely to close the
choke.
(1) Choke knob
When restarting immediately after stopping the
engine, you need not to pull out the choke knob.
(3)
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously.
Do not start the engine while the chain saw
hangs in one hand. The saw chain may touch
your body. This in very dangerous.
WARNING
(2) Chain oil
(2) Close
NOTE
WARNING
(3) Open
13 