Miele STB 201 Operating Instructions Manual page 57

Operating the Turbobrush
The Turbobrush is driven by the sucti-
on power of the vacuum cleaner. For
the best results and control, set the
vacuum cleaner for maximum suction,
and adjust the Turbobrush speed by
using the sliding air flow regulator
located on the top of the Turbobrush
housing.
^ For routine cleaning of low-to-me-
dium pile carpeting, or for deep-
cleaning in general, slide the air flow
regulator to the right as shown in the
far right illustration.
Deeper pile carpeting can be drawn
into the suction opening, thereby
obstructing air flow and impeding the
action of the roller.
^ This can be remedied by turning slid-
ing the air flow regulator to the left as
shown in the left hand illustration.
Important: When vacuuming rugs with
fringes, always start the Turbobrush on
the rug and pull it towards you onto the
surrounding floor. Never push the turbo-
brush over the fringes, as they may be
pulled off of the rug by the rotating
roller.
U
Operation
57