Carburetor - Makita Dolmar DCS460 Repair Manual

08 CARBURETOR

6
5
4
3 2
Removing the carburetor
CAUTION: Empty the fuel tank before
disassembling the carburetor!
Remove the hood and air filter.
Move combination switch 4 to STOP drücken.
Shut the choke valve 5.
Remove carburetor adjusting guide 1.
Disengage Bowden cable (arrow).
Unscrew screws 2 and 3 and pull them out.
CAUTION: There is fuel in the line. Briefly
open the tank cap to reduce pressure in
the fuel system.
Remove the carburetor 6, and carefully pull
off the fuel line.
9
8
1
10
11
Removing the intake manifold
Unscrew screws 7.
Unscrew screws 8.
Pull ignition cable out through slot 9.
Note: When assembling, make sure that the
ignition cable is pulled as far as possible
through the carburetor flange towards the
carburetor, in order to prevent the cable from
coming into contact with the cylinder.
Pull contact spring 10 up and out.
The intake manifold 11 can now be removed
along with the combination switch. When
doing so, disengage the contact wire (arrow)
from the carburetor bottom.
7
12
18
Removing the carburetor bottom
Unscrew 3 screws 12.
The carburetor bottom 16 and flange 15 can
now be removed. When doing so, press out the
fuel line 18 and pull off the low-pressure hose
13.
To separate the carburetor flange 15 from the
carburetor bottom 16, unscrew screw 14.
Assembly is in reverse order. When putting on
the carburetor bottom, guide the Bowden cable
through the opening 17. When installing the fuel
hose 18, guide the collar through then opening
very carefully.
Note: Do not twist the fuel line during
assembly. The recess A in the fuel line must
point towards the carburetor.
Visually check between the carburetor bottom
and the crankcase B to ascertain that the fuel
line did not get pinched.
13
14
15
16
B
A
17
19