Table of Contents
Advertisement
Hook Up Cable Service (CATV) and VCR
Connect a VCR and Cable service to the TV.
1
Locate the Antenna/Cable jack on the back of the
VCR.
2
Connect the cable that runs from the wall directly
to this jack, according to the diagram to the
right. As required, make the other connections as
shown to the right.
3
Remove the back of the remote, put in two AA
batteries.
4
Plug in the TV. Do not plug it into a switched
outlet. The TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not attempt to
operate it on DC Current.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
Leave the VCR and the television tuned to channel
three and use the cable box to change channels.
No A/V cables are included with your TV. Without
A/V cables, most VCRs will not play videocassettes
in stereo sound.
P A G E 1 0
back of
remote
Cable TV
wall jack
Round wire (75ohm)
TV back
ANTENNA
CABLE
VIDEO
MATRIX
IN
OUT
M.P.I.
R- AUDIO- L
IN
TV back panel
(expanded view)
A/V cables
not included
with TV
Cable TV
wall jack
Cable box
In
output
Out
switch
3 4
Round wire (75ohm)
TV back
ANTENNA
CABLE
VIDEO
MATRIX
IN
OUT
M.P.I.
R- AUDIO- L
IN
TV back panel
(expanded view)
A/V cables
not included
with TV
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Video
Audio
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Video
Audio
206-3489-O
Advertisement
Table of Contents
