Connections (Continued)
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your existing equipment.
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on the TV using the 75-ohm Coaxial
Cable supplied (R).
ote
If you use this connection, tune the TV to the
DVD+VCR's RF output channel (CH 3 or 4).
How to set the DVD+VCR's RF output channel
1. While the DVD+VCR is turned off, press and hold CH
(v/V) on the front panel for about five
seconds.
The unit will turn itself on and "RF 03" or "RF 04" appears in
the display window.
2. Use CH (v/V) on the front panel or v/V on the
remote control to change the RF output channel (CH
03 or CH 04).
3. Turn off and on the DVD+VCR.
Audio/Video connection
1 1
Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using the
video cable supplied (V).
2 2
Connect the Left and Right DVD/VCR AUDIO OUT
jacks on the DVD+VCR to the audio left/right in
jacks on the TV (A1) using the supplied audio
cables.
ote
If you use this connection, set the TV's source selector
to VIDEO.
Rear of TV
ANTENNA
INPUT
R
Rear of DVD+VCR
12
VIDEO
AUDIO INPUT
INPUT
R
L
A1
V
Optional, Preferred TV Connections
otes
You can watch and listen ONLY to DVD playback
through the connections shown below.
S-Video connection
1 1
Connect the S-VIDEO OUT jack on the DVD+VCR
to the S-Video in jack on the TV using an optional
S-Video cable (S).
2 2
Connect the Left and Right AUDIO OUT jacks of
the DVD+VCR to the audio left/right in jacks on the
TV using the supplied audio cables (A2).
Component Video (Color Stream
1 1
Connect the COMPONENT VIDEO OUT jacks on
the DVD+VCR to the corresponding in jacks on the
TV using an optional Y Pb Pr cable (C).
2 2
Connect the Left and Right AUDIO OUT jacks of
the DVD+VCR to the audio left/right in jacks on the
TV (A2) using the supplied audio cables.
Rear of TV
S-VIDEO
COMPONENT VIDEO INPUT
INPUT
Pr
Pb
S
C
Rear of DVD+VCR
®
) connection
AUDIO INPUT
Y
R
L
A2