PROBLEM
If you want to change the type of coffee You must remove all the beans present
After grinding, the coffee filter is empty The coffee grinder coffee funnel is
After grinding, there is too much coffee
in the filter
After grinding, the ground coffee in the
filter does not reach the "perfect dose"
CAUSE
in the machine
clogged
The "Smart Tamping Station" needs
cleaning
The quantity of ground coffee needs
adjusting
Over time the burrs wear down
16
SOLUTION
•
Empty the beans container (if neces-
sary, operate the coffee mill without
beans or use a vacuum cleaner to re-
move any remaining beans)
•
Attach the filter holder and operate
the coffee mill a number of times
without beans to free the coffee guide.
Attach the filter holder to the outlet
of the grinder (A18), lining it up with
"INSERT", then turning it to the right.
Grinding begins when the filter holder
reaches the CLOSE position and stops
automatically. Repeat until the filter is
empty
•
Place the new coffee in the beans
container
•
If the amount of coffee ground is not
enough to reach the perfect dose, pro-
ceed setting the appliance as for the
first use
Clean as described in section "5.10 Cleaning
the "Smart tamping station"". If the problem
persists, access the guide by opening the hatch
and free it using the brush)
Clean as described in section "5.10 Cleaning
the "Smart tamping station", then grind again
Adjust the quantity of coffee with the dial
(B2). If the dial is already in the max. position,
proceed as described in section "Extra grinding
adjustment"
Replace the burrs as described in section "5.9
Replacing the burrs"