Roland TM-6 PRO Data List page 17

Parameter
SETUP tab
Master Gain*1
Phones Gain*1
Direct Gain*1
Pad Effect to Direct*2
LoCut Freq*1
Master LoCut Sw*1
Phones LoCut Sw*1
Direct LoCut Sw*1
Master Direct Sw*2
Master Mono Sw*2
*1 The gain and low-cut effects are not applied to the TM-6 PRO's sound that is output via USB audio.
*2 This also applies to the sound of the TM-6 PRO that is output via USB audio.
Value
-24–+12dB
-24–+12dB
-24–+12dB
OFF, ON
20–200Hz
OFF, ON
OFF, ON
OFF, ON
NORMAL, DIRECT
STEREO, MONOx2
Explanation
Adjusts the volume of the MASTER OUT jacks (gain).
If the output volume of the TM-6 PRO is too loud, causing the receiving device to distort, you can
use this setting to lower the volume.
* Raising the volume excessively might cause distortion. Adjust this with care.
Adjusts the volume of the PHONES jack (gain).
Adjust the output from the PHONES jack to an appropriate volume.
* Raising the volume excessively might cause distortion. Adjust this with care.
Adjusts the volume of the DIRECT OUT jacks (gain).
If the output volume of the TM-6 PRO is too loud, causing the receiving device to distort, you can
use this setting to lower the volume.
This applies to all of the DIRECT OUT jacks.
If the Master Direct Sw is set to "DIRECT, " this also affects the output from the MASTER OUT jacks.
* Raising the volume excessively might cause distortion. Adjust this with care.
Specifies whether the pad effects (pad equalizer, transient, pad compressor, multi-effect) are
applied (ON) to the sound that is output from the DIRECT OUT jacks or are not applied (OFF).
If this is "OFF, " the pad effects are bypassed for the output from the DIRECT OUT jacks.
If the OUTPUT SETUP parameter Master Direct Sw is set to "DIRECT, " setting "Pad Effect to Direct" as
"OFF" will also bypass the pad effects for the output from the MASTER OUT jacks.
Cuts the frequency region that is below the specified frequency (low cut).
This setting is common to all output jacks.
Specifies whether the low-cut effect is applied (ON) to the sound that is output from the MASTER
OUT jacks or is not applied (OFF).
Specifies whether the low-cut effect is applied (ON) to the sound that is output from the PHONES
jack or is not applied (OFF).
Specifies whether the low-cut effect is applied (ON) to the sound that is output from the DIRECT
OUT jacks or is not applied (OFF).
Selects whether the MASTER OUT jacks will output the same signal as the DIRECT OUT jacks
(DIRECT) or not (NORMAL).
If this is set to "DIRECT, " the master compressor and master EQ effects are not applied to the output
from the MASTER OUT jacks, allowing you to use the MASTER OUT jacks as DIRECT OUT jacks (The
setting of the [MASTER] knob is effective.).
This setting also applies to USB audio output to the computer.
Selects whether the output of the MASTER OUT jacks is output in stereo (STEREO) or in mono
(MONOx2). If MONOx2 is selected, the same mono signal is output to L and R.
This is convenient when you're connecting to a mono-input amp.
MENU
17