Operation; Before Using; Control Panel; To Start The Appliance - Zanussi CZX 165 SI Instruction Booklet

OPERATION

Before using

Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate of
soda (5 ml to 0.5 litre of water).
Do not use soap or detergent as the smell may
linger. Dry thoroughly.

Control panel

A - Thermostat control knob
B - Pilot light

To Start the Appliance

Allow the appliance to stand for 2 hours after
installation.
Plug in the appliance and switch on at the mains
supply. Turn the thermostat control (A) to a midway
setting (3-4) and adjust the slider control, situated on
the back wall of the fridge section, to a midway
position between "MIN" and "MAX". The pilot light (B)
will illuminate. Leave the appliance for approximately
4 hours for the correct temperature to be reached
before placing food inside.
To switch off the appliance turn the thermostat
G
control to position " "

Setting the temperature

The temperature inside the appliance is regulated by
a thermostat with 6 temperature positions and an
G
"OFF" ( ) position.
Position 1 = minimum coldness
Position 6 = maximum coldness
Turn the thermostat control knob to the required
position.
The intermediate position is usually the most
suitable (3-4).
The thermostat control knob regulates the
temperature both within the fridge and the freezer
compartment. The thermostat setting can vary as the
temperature inside the appliance depends on the
following factors:
– room temperature
– how often the door is opened
– how much food is stored
– position of the appliance
6
1
5
2
4 3
A
Use of an air circulation slider
control - COOL FLOW CONTROL
Your appliance has an air circulation slider control
situated at the rear of the fridge compartment, which
controls the amount of cold air circulated through the
fridge compartment.
When the ambient temperature is between 10°C and
16°C, the slider control should be in the "MIN"
position.
When the ambient temperature is above 16°C the
slider control should be midway between "MIN" and
"MAX".
When the ambient temperature is very high (i.e. hot
summer days) position the slider control to "MAX".
MIN MAX
COOL FLOW CONTROL
COOL FLOW CONTROL
D757/1
B
MIN MAX
5