Advertisement
Quick Links
Advertisement
Summary of Contents for Peavey Elements Pole
- Page 1 ® Elements Pole Mounting System Installation Manual www.peavey.com...
-
Page 2: Customer Support
INSTALLER IS SOLELY RESPONSIBLE FOR THE FOLLOWING: • Complying with all applicable building codes (local and/or national) • Making sure that the Elements Pole Mounting System is appropriate for the specified install. • Using only parts supplied by Peavey. • Ensuring the safe installation of Pole Mounting System CAUTION: Before attempting to suspend these speakers, consult a certified structural engineer. -
Page 3: Component List
Elements Pole Mounting System ® Installation Manual COMPONENT LIST • Stainless steel cable straps Part number: 30903757 (x 4) • Speaker Mount assembly • Pole Mount assembly • Pole Mount assembly to Speaker Mount assembly bolts • Speaker to Speaker Mount bolts with washers Part numbers: Part Numbers: Bolt: 31502138 (x 3) - Page 4 ASSEMBLY INSTRUCTIONS 1. Preset angle - Start by loosening the pivot bolt (1) and removing the angle set bolt (2). If you know the desired angle for the speaker beforehand, adjust the angle and replace the angle set bolt. Tighten the pivot bolt, while hand tightening the angle set bolt. Do not over tighten. 2.
- Page 5 3. Mount speaker mount to speaker - Secure speaker mount assembly to speaker. With the four screws from the rear panel of the speaker removed, attach assembly to speaker as shown. * Note: start with top left screw, then top right. Tighten screws, and then use your hand to align the holes at the bottom of the bracket.
- Page 6 5. Pole mount (strap tension plate) - Place stainless steel cable straps into the pole mount as shown. The steel straps should be spaced one on top, one on bottom, and two in the center. Optional Eye bolt can be placed here. 6.
- Page 7 The straps should be installed with the latch point (the joint where the tip of the strap tab is inserted into the slotted end of the strap) positioned firmly against the pole, opposite the pole bracket. Positioning the straps in this manner will ensure proper seating. Using a pair of pliers, secure the pole mount to the post by pulling the slack out of the straps.
- Page 8 7. Once the straps are secure, tighten the tensioning bolts (part number: 31502136) to ensure secure mounting. 8. The Speaker mount assembly features a lip (3) that will allow the installer to rest the speaker mount to the pole mount while being able to free his or her hands for inserting bolts. CAUTION: This feature is a temporary, one time during installation feature ONLY.
- Page 9 9. Secure pole mount to speaker mount using three bolts and nuts provided. (see picture above) 10. Tighten all screws. Use only the correct mating hardware. All associated rigging is the responsibility of others. CAUTION: If any of the brackets or hardware have been damaged or distorted, DO NOT USE and DO NOT FLY the cabinet until they can be replaced or repaired!
- Page 10 SPEAKER MOUNT PARTS LIST...
- Page 11 POLE MOUNT PARTS LIST...
- Page 12 ELEMENTS POLE MOUNTING SYSTEM ® Specifications: Overall Dimensions Including Hardware (HxWxD): 15.83” X 6.46” X 14.60” Weight: 5.53 kg / 12.2 lbs. (Fully Assembled) Material: • 12 gauge stainless steel construction • stainless steel hex head bolts, washers and nylon locking nuts •...
- Page 13 NOTES:...
- Page 14 NOTES:...
- Page 15 NOTES:...
- Page 16 Features and specifications subject to change without notice. Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com ©2014 80307516...