ACR Electronics OLAS CORE Accuracy Testing

Testing the alarm
1. Connect the OLAS app to the Core. For more
information on how to do this please refer to the Core Setup
Instructions.
3. Switch off the OLAS transmitters.
OLAS tag: press the button for 4 seconds, until a red flash is
seen. OLAS Float-On: press the button for 4 seconds until the bi-
color LED flashes red.
5. Press the control switch on the Core once or tap "Continue to
Recovery" in the App. This puts the system into pause state.
MOB
Tom
Overboard!
OR Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
www.acrolas.com
0438 Near
1152 Near
0347 Near
MOB
2. Ensure all OLAS transmitters are seen on the OLAS app
homescreen.
4. The alarm will occur after your set 'Alert Time'
The default Alert Time is 3 seconds.
6. Press the control switch again once. 3 beeps will sound
to indicate that the transmitter is still missing, and the
system is still in pause state.
0438
0347
Tom
Overboard!
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery