Table of Contents
Advertisement
Installing the gateway in the rack
Use these instructions to install the N7x50T series gateway in the rack.
>55 kg (121.2 lb)
1. If attached, carefully remove the front bezel of the N7x50T series gateway with two hands by
grasping the openings on either side of the bezel.
2. From the front of the rack, place the storage system onto the rails and slide it in until the front
mounting bracket of the storage system is flush with the frame rails of the rack.
3. At the front of the rack, using four silver pan head M5 screws in the H3 and H7 holes, secure the
system unit to the rack by threading the screws through the system unit bracket and the rack frame
rail into the threaded rail nuts. Repeat this for the second rail. Tighten the screws using a screwdriver.
4. Replace the front bezel of the N7x50T series gateway by snapping it back onto the storage system
chassis.
5. From the rear of the rack, use four M5 flat head screws 1 to attach the rear tie-down bracket 2 to
both the left and right rails, as shown in Figure 6. The tie-down bracket should fit over the rear of the
system unit.
1
Figure 6. Attaching the rear tie-down bracket
6. Repeat steps 1 to 5 to install the second enclosure of an HA pair.
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It takes specially
trained persons, a lifting device, or both to safely lift this part or unit. (C011)
2
Installation and setup instructions
7
Advertisement
Table of Contents
