Manufacturer Testing And Verification - Tiger TR7 Instruction Manual

Store the unit in a clean and dry place.
Protect the unit including all accessories against contamination, humidity and damage by means of a suitable cover.
Protect against corrosion.
Wipe off all dirt and water.
A light oil film should be applied to the chains , hook pins and hook latch pins.
Since the brake disks may freeze at temperature below 0°C, the unit s hould be stored with closed brake. Turn the
hand chain wheel clockwise to this effect and hold the load fall at the same time.
If the unit is to be used again after i t has been taken out of service, it must first be inspected again by a competent
person.
Disposal
When the product comes to the end of its lifecycle, after taking the unit out of service, recycle or dispose of the parts of the
unit respecting local and national environmental regulations.
6.

Manufacturer Testing and Verification

This product was manufactured under our single -unit control of quality and was passed with strict inspection in accordance
with our inspection standards.
Capacity (tonne) WLL (kg)
0.5 500
1 1000
1.5 1500
2 2000
3 3000
5 5000
Declaration of Conformity
Products are tested in line with the requirements within applicable sections of the European standard BS EN
13157: 2004+A1:2009, the Australian standard AS1418.2, the American standard ANSI/ASME B30.16, and the South African
standard SANS 1594 . All items comply with the essential health and safety requirements of the Machinery Directive
2006/42/EC. Tiger chain blocks are third party verified by SGS Certificate Number MDC 1302.
Unit 1, eld Industrial Estate,
Willowburn Avenue,
ALNWICK, NE66 2DG
Email: info@ gerli ing.com
Test Load (kg)
750
1500
2250
3000
4500
7500
www.tigerlifting.com
www. gerlif ng.com
Page 10 of 18