Starting A Washing Programme - Zanussi Electrolux DE 6554 Instruction Book

Starting a washing programme

1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Press the On/Off push button
The On/Off indicator light will come on.
5. Setting and starting the programme
Press the push button corresponding to the required
programme (see "Washing programmes" chart).
The indicator light corresponding to the programme
illuminates and the phase indicator lights foreseen for
that programme start flashing.
It is possible to change the programme selection simply
pressing the push button of another programme within 6
seconds.
Once the programme has started the phase indicator
lights will turn off except for the phase under way.
6. Interrupting/cancelling a washing
programme in progress
Change or interrupt a washing programme in
progress ONLY if it's absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme in
progress
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
b) Press the On/Off push button (in this case all the
indicator lights turn off). Press the On/Off push button
again; the programme will start from the point in
which it was interrupted.
To cancel a washing programme in
progress
A programme in progress can be cancelled at any time.
Press for about 3 seconds the push button of the running
programme until all indicator lights are off.
Only the On/Off indicator light will remain illuminated.
It is now possible to select a new washing programme.
7. End of the washing programme
The dishwasher will automatically stop and the end of
programme phase indicator light will illuminate.
The indicator light of the programme just ended will
remain on.
The dishwasher has finished the programme only when
the end of programme indicator light (END) is illuminated.
If you do not wait for the end of the programme it will not
be possible to start a new programme until the previous
programme has been cancelled.
(For instructions on how to cancel a programme see the
corresponding instructions).
If during the drying phase (DRY indicator light
illuminated) the dishwasher door is opened or the On/Off
push button is pressed, the running programme is
automatically cancelled and the machine returns to
setting mode (in this case it is possible to select a new
programme without cancelling the previous)
Switch off the dishwasher by pressing the On/Off push
button, the On/Off indicator light turns off.
Open the door and wait a few minutes before removing
the dishes; in this way they will be cooler and the drying
will be improved.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
13