Fm Operation; Scanning For Radio Stations; Auto Tuning; Manual Tuning - JVC TH-WL701B Instruction Manual

FM Operation

1. Press SOURCE on the unit repeatedly or FM on the remote control to select FM radio.
2. Press MENU to display the FM menu. Press
/OK to confirm.
press
Scan
Audio
System

Scanning for Radio Stations

The unit will automatically select a FM radio station with a good signal.
1. While listening to an FM station, press SCAN button to activate automatic
programming. All available stations will be programmed in the order of waveband
reception strength.
2. The first programmed radio station is played automatically.
3. To select and listen to a saved radio station, press
preset radio station.

Auto Tuning

Press and hold the
tuner will stop searching after tuning into a radio station.

Manual Tuning

Press /
the / buttons will adjust the frequency by 0.05MHz.
• The search may not stop at a station with a very weak signal.
• If reception is still poor, try to adjust the DAB / FM aerial location.

Presetting Stations Manually

You can store up to 20 of your favourite stations to the memory. This will enable you to
access your favourite stations quickly and easily.
1. To store a preset station, you must first be listening to the station that you would like to
save, press PROG. The preset number will flash on the display.
2. Then press
confirm.
3. The station will be stored and the screen will then show "STORE".
30
Allows the auto scan function to be able to find weaker
signals or strong signals.
Select Stereo or Mono.
Reset your unit back to the factory settings.
/ for a few seconds, the tuner will start searching for a station. The
buttons repeatedly to search for the desired frequency reception. Each press
to select your desired preset station number and then press PROG to
/ to scroll through the options then
/ to skip to the previous / next