Emptying The Water Reservoir; Cleaning The Air Intake Grille; Cleaning The Drum - Zanussi TCE 7227 W Instruction Booklet

Clean it with a brush and rinse it under the shower if
necessary.
Also clean the outside, removing all fluff.
Clean the rubber seal round the condenser cabinet
and in the inner part of the small door with a damp
cloth.
Important! Do not use pointed objects or utensils to
clean the spaces between the plates, as this could
damage the condenser and make it permeable.
Re-fit the condenser, turn the red stops upwards and
close the door.
Do not use this appliance if the condenser
has not been fitted.
E E m m p p t t y y i i n n g g t t h h e e w w a a t t e e r r
r r e e s s e e r r v v o o i i r r
Water extracted from the laundry condenses inside
the machine and is collected in a reservoir.
The reservoir must be emptied after each drying
cycle to ensure efficient operation when the machine
is next used. The pilot light
reminds you this operation.
Proceed as follows:
• Pull out the reservoir
• Turn it upside down and let water flow down
• Re-fit the reservoir
The reservoir must be re-inserted correctly.
If this is not done the pilot light
next drying and the programme stops, leaving the
laundry damp. The buzzer will sound.
After emptying and inserting the reservoir the
(Water reservoir full)
comes on during
"START/PAUSE"
again to allow the programme to continue.
Handy tip: The condensed water may be used in a
steam iron or to top up a battery, etc. In this case it
must be filtered (e.g. through a coffee filter).
C C l l e e a a n n i i n n g g t t h h e e a a i i r r i i n n t t a a k k e e
g g r r i i l l l l e e
Using a vacuum cleaner remove the fluff from the air
intake grille at the back of the appliance.
C C l l e e a a n n i i n n g g t t h h e e d d r r u u m m
When your laundry does not reach the desired degree
of dryness, in other words, when it turns out either
too dry or too damp, we advise you to clean the
inside of the drum with a cloth soaked with vinegar.
This will eliminate the slight patina that has formed
in the drum (due to residues of detergent and
softeners used in the washing, and to the lime
contained in the water), which prevents the probes
from detecting the correct degree of dryness.
11
button has to be depressed