Basic Setup - Yamaha DME Series Setup Manual

1. Installing the Software

2. Basic Setup

Connecting a single DME unit directly to a computer via USB cable
This section covers the most basic configuration
– that is, using a single PC to control a single DME unit.
2-1. Preparation
Before launching DME Designer, it is critical that the DME unit is turned on and then connected to the computer using a USB cable.
Once the DME unit has been connected, launch DME Designer.
Upon launch, two windows will be displayed.
In order to setup the currently-connected DME unit for editing,
double-click [DME] at the left of the Designer window.
Next, either
double-click the
currently connected
DME unit (a
DME24N in this
case) or drag and
drop it to the editing
area located to the
right of the list.
2. Basic Setup 3. Advanced Setup
(via USB cable)
Drag and drop
4. In-depth information
(via Ethernet cables)
In response to this action, the Device Group and Sampling Frequency
Settings window will be displayed. Click the [OK] button to proceed.
* Group settings are not
necessary when only one
DME unit is connected.
* The sampling rate can
be changed later on.
04
on DME Units DME-N Network Driver Settings
USB cable
Main Panel window
Designer window
Appendix: Detailed