Table of Contents
Advertisement
Accessories
External view
1
2
3
The use of any accessories except for those provided might result in
damage to the unit. M ake sure only to use the accessories shipped w ith
the unit, as show n above.
Installation Procedure
1. To prevent short circuits, remove the key from the ignition and
disconnect the - terminal of the battery.
2. M ake the proper input and output w ire connections for each unit.
3. Connect the w ire on the w iring harness.
4. Take Connector B on the w iring harness and connect it to the
speaker connector in your vehicle.
5. Take Connector A on the w iring harness and connect it to the
external pow er connector on your vehicle.
6. Connect the w iring harness connector to the unit.
7. Install the unit in your car.
8. Reconnect the - terminal of the battery.
9. Press the reset button.
Number of items
..........................................1
..........................................2
..........................................1
2CA U TION
• If your car is not prepared for this special connection-system,
consult your Kenw ood dealer.
• Only use antenna conversion adapters (ISO-JASO) w hen the
antenna cord has an ISO plug.
• M ake sure that all w ire connections are securely made by
inserting jacks until they lock completely.
• If your vehicle' s ignition does not have an ACC position, or if the
ignition w ire is connected to a pow er source w ith constant
voltage such as a battery w ire, the pow er w ill not be linked w ith
the ignition (i.e., it w ill not turn on and off along w ith the
ignition). If you w ant to link the unit' s pow er w ith the ignition,
connect the ignition w ire to a pow er source that can be turned
on and off w ith the ignition key.
• If the fuse blow s, first make sure that the w ires have not caused
a short circuit, then replace the old fuse w ith one w ith the same
rating.
• Insulate unconnected w ires w ith vinyl tape or other similar
material. To prevent short circuits, also do not remove the caps
on the ends of the unconnected w ires or the terminals.
• Connect the speaker w ires correctly to the terminals to w hich
they correspond. The unit may receive damage or fail to w ork if
you share the - w ires and/or ground them to any metal part in
the car.
• After the unit is installed, check w hether the brake lamps,
indicators, w ipers, etc. on the car are w orking properly.
• If the console has a lid, make sure to install the unit so that the
faceplate does not hit the lid w hen closing and opening.
— 21 —
Advertisement
Table of Contents
