To Stop Automatic Page Change; To Select A Subcode Page; To Exit Teletext; To Display The Time - Sharp 21LF-90H Operation Manual

ENG-2163-1548 UK-PAL-TEK SCART-FAV-STEREO-SHARP-AK44-TV2.p65
Downloaded from: http://www.usersmanualguide.com/

To Stop Automatic Page Change

The teletext page you have selected may
contain more information than can be dis-
played on one screen, in such cases the
page will update periodically.
• Press “ “ button to stop the automatic
page change.
• Press “ “ button again to allow the next
page to be displayed.

To Select a Subcode Page

Subcode pages are subsections of long
Teletext pages that can only be displayed on
the screen one section at a time.
• Select the required Teletext page.
• Press “ “ button.
• Select the required subcode page number
by pressing four digit buttons (e.g. 0001).
• If the selected subcode page is not displayed
in a short time, press “
programme will be displayed on the screen.
• Teletext page number will be displayed on
the upper left corner of the screen when the
selected page is found.
• Press “ “button to display the selected
Teletext page.

To exit Teletext

• Press “ 79 ” button. The screen will switch
to TV mode.

To Display the Time

• While watching a TV programme with Tele-
text transmission press “
current time information, captured from Tele-
text will be displayed at the upper middle of
the screen.
21
• If the programme being watched does not
have Teletext transmission, no iformation
will be displayed.
Connecting external
equipment
There is a wide range of audio and video
equipment that can be connected to your TV.
The following connection diagrams show
you where the different equipment should
be connected at the back or the front side of
the TV.

Via the Euro connector

Your TV set has one Euro connector
(SCART) socket. If you want to connect exter-
nal equipment (e.g. video, decoder, etc.)
which have Euro connectors, to your TV, use
SCART terminal.
If an external device is connected via Euro-
connector socket the TV will be switched to
“ button. TV
AV mode automatically.

RGB mode

If a piece of equipment outputs RGB signals
use the SCART socket

Via the ANT (aerial) socket

If you want to connect to your TV, peripherals
like video recorders or decoders, but the de-
vice you want to connect does not have
Euroconnector, you should connect it to the
ANT input of your TV set.
If the VCR is connected via antenna input
it is suggested to use the Programme 0.

Decoder

Cable TV offers you a wide choice of pro-
grams. Most of them are free, others are to
be paid for by the viewer. This means that
you will need to subscribe to the broadcast-
ing organisation whose programmes you
wish to receive. This organisation will supply
you a corresponding decoder unit to allow
“ button. The
the programmes to be unscrambled.
For further information ask your dealer. See
also the booklet supplied with your decoder.
- 21 -
as this is RGB ready.
06.01.2004, 15:37