Download
Share
Print this page
Jawbone UP3 Charging Instructions
  1. Manuals
  2. Brands
  3. Jawbone Manuals
  4. Fitness Trackers
  5. Up3
  6. Charging instructions

Jawbone UP3 Charging Instructions

Hide thumbs Also See for UP3:
1
2
3
4
5

Advertisement

Quick Links

Download this manual

Charging Instructions

First, hold the band's strap with the loop at the bottom then connect the charging cable from the
right. The pins from the charging cable will magnetically hold the band in place.
Next, insert the charging cable into your computer or a standard USB wall adapter. You can bend
the charging cable if needed.
The icons on the face of the band will illuminate and cycle through to indicate that the tracker is
charging.

Advertisement

loading

Related Manuals for Jawbone UP3

Summary of Contents for Jawbone UP3

  • Page 1 Charging Instructions First, hold the band’s strap with the loop at the bottom then connect the charging cable from the right. The pins from the charging cable will magnetically hold the band in place. Next, insert the charging cable into your computer or a standard USB wall adapter. You can bend the charging cable if needed.
  • Page 2 The icons will stop cycling and the runner icon will solidly glow once the band is fully charged. A full charge takes approximately 60–90 minutes. Click here to view a brief tutorial video on charging your band. Expected Behavior When charging, each of the three band icons cycle through, pulsing on and off. If your tracker’s battery is completely drained, the orange runner icon on your band may remain lit for up to 5 minutes before displaying expected charging behavior.
  • Page 3 If your tracker’s battery is completely drained, the orange runner icon on your band may remain lit for up to 5 minutes before displaying expected charging behavior. Wearing and Caring In order to ensure comfort and accurate tracking—including heart rate capture and advanced sleep detection—it’s important to wear your band properly.
  • Page 4 Thread the strap through the loop then tighten the strap to hold the loop in place. The fit should be snug, but not too tight. Note where the clasp lands then remove the band and adjust the buckle accordingly. Put the band back on and insert the clasp just over the buckle to secure the band to your wrist.
  • Page 5 To remove the band, lift the strap and slide the clasp away from the buckle. Caring For Your Band Your UP3 is rain, splash and sweat-resistant. However, your band should be removed before showering, swimming or other extreme conditions (such as saunas and steam rooms).