Connecting To The Pc Using Cc31Xxemuboost Board; Cc31Xxemuboost Board - Texas Instruments SimpleLink Wi-Fi BoosterPack CC3120 User Manual

Connecting to the PC Using CC31XXEMUBOOST Board

3 Connecting to the PC Using CC31XXEMUBOOST Board
3.1

CC31XXEMUBOOST Board

3.1.1 Overview
The CC31XXEMUBOOST board is designed to connect the BoosterPack module to a PC through a USB
connection. This connection updates the firmware patches, which are stored in the serial flash on the
BoosterPack, and in software development using SimpleLink Studio. The board is also used to measure
the RF performance using a software tool named RadioTool. For more information, see the
CC32xx Radio Tool
3.1.2 Hardware Details
Figure 13 shows the CC31XXEMUBOOST board.
The CC31XXEMUBOOST board has two FTDI ICs to enumerate multiple COM and D2XX ports.
gives the details of the ports.
Port Number Port Type
1 D2XX
2 D2XX
3 VCP
4 VCP
14
CC3120 SimpleLink™ Wi-Fi
Solution
wiki page.
Figure 13. CC31XXEMUBOOST Board
Table 6. Ports Available on J6
Usage
SPI port for SimpleLInk Studio
GPIO for SimpleLink Studio
COM port for flash
programming
NWP
®
BoosterPack™ Plug-In Module and IoT
Copyright © 2017–2018, Texas Instruments Incorporated
Copyright © 2017, Texas Instruments Incorporated
Comments
Control the nRESET, nHIB, IRQ
Network processor logger output. Used with specific
tools to analyze the network processor logs. For TI use
only.
SWRU457A – February 2017 – Revised August 2018
www.ti.com
CC31xx &
Table 6
Submit Documentation Feedback