Yamaha CDC-775 Owner's Manual page 23

Display information during programming
Random sequential tape programming
The unit will automatically program tracks on a disc in random
sequential order for recording to tape.
1
Follow steps 1 – 4 on page 21.
2
The unit will automatically program tracks for side A and
side B separately considering the tape's total time.
* The programmed track numbers and the total
number of tracks for side A and B are displayed for a
short time.
3
Start recording on the tape deck and press the PLAY
button on this unit's remote control transmitter at the
same time.
4
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and,
at the same time, press the PLAY or PAUSE button on
this unit's remote control transmitter.
PROG
1 2 3 4 5
6 7 8 9 10
PROG
1 2 3 4 5
6 7 8 9 10
RANDOM
Shows the side of the tape and the program number for the
track to be programmed next.
Shows the selected disc and track number.
Shows the total remaining time on the side of the tape.
Programmed track numbers light up and programmable
track numbers among the unprogrammed ones blink.
* If "A-1" does not appear in the display after the PROG
button is pressed, press the TIME display mode-select
button.
* If, during programming, the TIME display mode-select button
is pressed, the program number display can be changed to
display the total remaining time on the side of the tape. To
return to the previous display, press the TIME display mode-
select button once again.
SYNCHRO PEAK DIMMER
2
REPEAT RANDOM TAPE
1 2 3
6 7 8
+ 1 0
FILE EDIT
CAPS
DISC SKIP/
CHARACTER
TEXT MODE
DISC MODE
4
DISC SCAN SKIP/SEARCH
STOP PAUSE
Notes
Because the programmed data changes every time the
RANDOM button is pressed, the amount of time remaining
at the end of the tape also changes accordingly.
It is recommended that you use a tape that is slightly longer
in length than the CD you are recording, because the
programmed tracks on a CD may not fit properly into the
time allowed on each half of the tape.
CD synchronized recording function can be used if your tape
deck is compatible with it.
In this case, in steps 3 and 4, press the SYNCHRO button
and then press the PLAY button on this unit's remote control
transmitter. Recording automatically begins.
(For details, refer to page 20.)
Display information during programming
Shows the number of programmed tracks for each side in
turn just after the automatic programming is finished, and
then it is replaced by the number of the first programmed
track for side A.
Shows the total time of programmed tracks for each side.
Shows the programmed track numbers for each side.
OPEN/
TIME
CLOSE
CLEAR PROG
4 5
9 0
INDEX
FILE MODE
ENTER
TEXT SRCH
OUTPUT LEVEL
PLAY
3, 4
PROG
1 3 5
7
23