Parts And Assembly - Guardian 7001 Use & Care Instructions Manual

READ AND SAVE THESE INSTRUCTIONS
WARNINGS
Failure to comply with the warnings listed below may
result in electric shock or serious injury.
This product should be used only in accordance with the specifications outlined in this
manual. Usage other than what has been specified here may result in serious injury.
WARNING: THE CORDS, WIRES AND/OR CABLE SUPPLIED WITH
THIS PRODUCT CONTAIN CHEMICALS, INCLUDING LEAD OR LEAD
COMPOUNDS, KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
CANER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.
WASH HANDS AFTER USING.
(CALIFORNIA CODE OF REGULATION PROPOSITION 65)
• Disassembly, repair or remodeling by an unauthorized person may result in serious harm
and will void the manufactures warranty.
• Manufacturer does not accept any liability for damage in the case of the unit being
placed incorrectly.
• Do not use if unit is damaged.
• Do not handle the unit with wet hands.
• Recycle batteries properly.
WARNING. Contains Strong Magnetic Sensor
Can be harmful to pacemaker wearers and others with medical implants.
Keep credit cards, computer disks, and other magnetic storage devices away
from the magnet. Keep electronic devices, such as computers, away from the
equipment because exposure to the magnetic field may result in malfunction
or permanent damage to such devices.

PARTS AND ASSEMBLY

Power Button
Main Module
Sensor
(magnetic)
Screws
(optional)
E-2
2 AA Batteries
(included)
LED Signal
SET UP INSTRUCTIONS - INSTALL BATTERY
1. Loosen the screw on the main module
with a screwdriver.
3. Install the 2 AA batteries in
compartment aligning polarity.
Tailgate Alert INSTALLATION
SELECT LED SIGNAL, MODULE and SENSOR LOCATIONS FOR INSTALLATION IN TRUCK
Before adhering, determine location of all 3 components using following guidelines.
After marking locations for each component, clean all surfaces where components
will be placed with rubbing alcohol.)
MODULE/LED SIGNAL:
Select location on the inside of the truck bed side panel to adhere the Module.
Select a location that allows the LED signal to rest on the top of the truck and direct the
LED light to the drivers side mirror. The driver should see the LED in the side mirror clearly
(fig. 1). LED signal device aligns with drivers side mirror. Bulb facing forward (fig. 2).
1
2. Insert flat head screwdriver into opening
on both sides of module cover and pry to
remove cover.
4. Realign cover tabs with slots and
assemble making sure its properly sealed.
Return screw and tighten with screwdriver.
2
E-3