Greenheck FGI Assembly Instructions Manual page 7

Step – 8 HOOD RAIL ASSEMBLY
NOTE: For easier assembly and lifting elevate hood rail assembly on blocks.
Lay out hood rail assembly and hood end angles, see Figure 6. Install thread cutters (hardware kit # 415041 - 5/16-
18 x 1 inch) from underneath, first through hood end angles and second hood rail assembly.
NOTE: Use a builders square to ensure the corners of the frame are as close to 90º as possible.
USE PROVIDED
HARDWARE KIT # 415041
5/16 -18 x 1 in.
THREAD CUTTER
High Wind - 2 Fabra hood B #471321
Figure 6
Step 9 – Install HAT CHANNEL
Place diagonal end panel supports with the formed angle running the length of the part facing out and slots next
to hat channel. Fasten diagonals with whiz nut (hardware kit # 415456). Leave wiz nuts snug and DO NOT tighten.
Lift hat channel into place. The diagonals will support the hat channel as it is being installed. Use thread cutters
(hardware kit # 415456) to attach the hat channel to the diagonal end panel supports. Tighten wiz nuts.
USE PROVIDED HARDWARE KIT
# 415041 AND 415456
5/16 -18 in. WHIZ NUT
Figure 7
NOTE: Adjustment of the hat channel may be needed. Ensure there is no more than an 1/8 inch gap between the hat
channel and hood panel.
®
5/16 -18 x 1 in.
THREAD CUTTER
5/16 -18 x 1 in.
THREAD CUTTER
5/16 -18 in. WHIZ NUT
5/16 -18 x 1 in.
THREAD CUTTER (BOTH SIDES)
5/16 -18 in. WHIZ NUT
HOOD END ANGLE
5/16 -18 x 1 in.
THREAD CUTTER
HOOD RAIL ASSEMBLY
HAT CHANNEL
5/16 -18 x 1 in.
THREAD CUTTER (BOTH SIDES)
DIAGONAL END PANEL SUPPORT
5/16 -18 in. WHIZ NUT
Fabra Hood • Form F 7