Table of Contents
Advertisement
Number of tests repeated). After the
tenth time that the test is canceled, the
time entered in 'Min. time distance from
test' is kept again.
If the analysis of the hysteresis pinpoints
'Friction', the positioner generates a corre-
sponding status message.
Diagnosis > Status messages > Extended
− Friction:
,
,
4.2.2
Resetting single status
messages
The diagnostic parameters and measured
data analysis from the 'Drive signal dia-
phragm hysteresis' test are reset by selecting
and executing the command "Reset 'Drive
signal diagram hysteresis measured data".
Diagnosis > Status messages > Reset
− Reset 'Drive signal diagram hysteresis mea-
sured data'
EB 8389S EN
,
Tests
61
Advertisement
Table of Contents
