When installing your NS-IW360C in-ceiling speakers, be aware of the product weight (See specification page) and the sturdiness of the material into which you are installing the speaker.
After unpacking, check that the following items are contained. 10-9/32” 3-3/4” NS-IW360C Speaker System x2 Pencil Sturdy wire (such as a coat hanger) These speakers are not magnetically shielded. Avoid installing the speakers too close to your TV. Stereo For best stereo performance, install the left and right speakers at equal distance from the listening position.
Before installation, check to ensure that the area you are installing the speaker is free of any ceiling joints, by tapping the ceiling or using a stud finder. If you wish to paint the speaker frame and grill, please refer to page 7 “PAINTING THE SPEAKER FRAME AND GRILL”...
Page 5
Connect the speaker cable to the speaker and your receiver. Please refer to page 6, “CONNECTIONS” section for detailed instructions. Place the speaker into the ceiling. Tighten each of the four screws evenly until the clamps at the back of the frame grip the ceiling to secure the speaker.
Loosen Black (–) (–) CONNECTIONS + – When using a banana plug 1 Tighten the terminal knob. 2 Insert the banana plug into the terminal. Tighten Red (+) NS-IW360C Banana plug...
PAINTING THE SPEAKER FRAME AND GRILL The speaker frame and grill can be painted to match your room décor. Use high quality spray paint and select a well ventilated area before proceeding. Painting the frame 1 Remove the speaker from the ceiling if it is already installed.
(6) Labor & materials required to remove and reinstall the loudspeaker. (7) Any unit which has not been purchased by the consumer directly from an authorized YAMAHA dealer in the USA or Puerto Rico. If you are uncertain as to whether a dealer has been authorized by YAMAHA, please contact YAMAHA at the telephone number shown below.