General Information; Safety; Appliance Description - AEG DDLT PinControl 13 Operation And Installation

OPERATION

1. General information

The chapters "Special information" and "Operation" are
intended for both users and qualified contractors.
The chapter "Installation" is intended for qualified con-
tractors.
Note
Read these instructions carefully before using the
appliance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1 Safety instructions
1.1.1 Structure of safety instructions
KEYWORD Type of risk
!
Here, possible consequences are listed that may re-
sult from failure to observe the safety instructions.
» Steps to prevent the risk are listed.
1.1.2 Symbols, type of risk
Symbol Type of risk
Injury
!
Electrocution
Burns
(burns, scalding)
1.1.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in seri-
ous injury or death.
WARNING Failure to observe this information may result in seri-
ous injury or death.
CAUTION Failure to observe this information may result in
non-serious or minor injury.
1.2 Other symbols in this documentation
Note
General information is identified by the adjacent
symbol.
» Read these texts carefully.
Symbol Meaning
Material losses
!
(appliance damage, consequential losses and envi-
ronmental pollution)
Appliance disposal
» This symbol indicates that you have to do something.
The action you need to take is described step by
step.
1.3 Units of measurement
Note
All measurements are given in mm unless stated
otherwise.

2. Safety

2.1 Intended use
The appliance is intended for domestic use. It can be used
safely by untrained persons. The appliance can also be
used in non-domestic environments, e.g. in small busi-
nesses, as long as it is used in the same way.
This pressure appliance is designed to heat DHW. The
appliance can supply one or more draw-off points.
Any other use beyond that described shall be deemed
inappropriate. Observation of these instructions and of
the instructions for any accessories used is also part of
the correct use of this appliance.
Note
This appliance is not approved for reheating pre-
heated water.
2.2 General safety instructions
CAUTION Burns
During operation, the tap can reach temperatures in
excess of 60 °C. There is a risk of scalding at outlet
temperatures in excess of 43 °C.
WARNING Injury
!
The appliance may be used by children aged 3 and
up and persons with reduced physical, sensory or
mental capabilities or a lack of experience and know-
how, provided that they are supervised or they have
been instructed on how to use the appliance safely
and have understood the resulting risks. Children
must never play with the appliance. Children must
never clean the appliance or perform user mainte-
nance unless they are supervised.
Material losses
!
The user should protect the appliance and its tap
against frost.
2.3 Test symbols
See type plate on the appliance.

3. Appliance description

The hydraulically controlled instantaneous water heater
heats the water as it flows through the appliance. The
heating output starts automatically as soon as a tap is
opened and the starting flow rate is exceeded (see chap-
ter "Specification / Data table"). The water volume and
temperature can be adjusted at the tap.
You can choose between 2 output stages. Two further
output stages are hydraulically controlled in relation to the
flow rate.
The flow rate controller compensates for pressure fluc-
tuations, thereby ensuring largely stable temperatures.
The controller limits the throughput, thereby ensuring an
adequate increase in the DHW temperature at all times.
Heating system
The bare wire heating system has a pressure-tested
plastic casing. The heating system is suitable for hard
and soft water areas and is largely insusceptible to scale
Operation
17