Related Manuals for Sentry DCCP Reboiler
Summary of Contents for Sentry DCCP Reboiler
- Page 1 Original Instructions Installation, Operation & Maintenance Manual Sentry DCCP Reboiler Single Line Conditioning Module S-SW-IOM-00255-17 07-19...
-
Page 2: Table Of Contents
Otherwise, injury, damage, or both may result. Copyright © 2019 by Sentry Equipment Corp. All rights reserved. All product and company names are property of their respective owners. This document contains proprietary information. No part of this document may be photocopied or reproduced without the prior written consent of Sentry Equipment Corp. -
Page 3: Safety Information
Electrical equipment marked with this symbol may not be disposed of in European public disposal systems. In conformity with European local and national regulations, European electrical equipment users must now return old or end-of-life equipment to the manufacturer for disposal at no charge to the user. Sentry DCCP Reboiler... -
Page 4: General Safety Precautions
High pressures! This equipment may contain fl uids at very high pressures . Prior to installing, removing, or maintaining this equipment, ensure that the equipment is isolated from all connecting piping, the equipment is depressurized, the contents have been drained, and the equipment is cool . Sentry Equipment Corp... -
Page 5: General Description
Regenerative Cooling Option The Sentry DCCP reboiler has the option for designated cooling water or regenerative cooling. With the regenerative cooling option, cooling water is not required. Instead, the sample flow path is altered so that the sample cools itself while running through the DCCP panel. -
Page 6: Specifications
ƒ 61 lb (28 kg) for model DCCP-013100 (pictured on cover) Pressure rating ƒ 100 psig (7 barg) Temperature rating ƒ 130°F (54°C) with RC-100 before degas Sample flow ƒ 100–150 cc/minute Sample inlet/outlet connections ƒ 1/4 inch tube fitting Sentry Equipment Corp... -
Page 7: Installation
. Never attempt to install a metric equivalent tube, pipe, or fittings into these connection points . Lift unit by the stainless steel backplate . Do not lift using mounted components as these could break, damaging the equipment and possibly causing personal injury . Sentry DCCP Reboiler... - Page 8 To accomplish this, the sample outlet from the panel must be even with the cross over section of the degas chamber. It is important to follow these instructions to obtain accurate conductivity measurements. Sentry Equipment Corp...
- Page 9 Electrical Wiring Diagram (see drawing in back). ƒ Supply wire must be between AWG 12 (3.31 mm ) and AWG 4 (21.15 mm ƒ Supply wire must be rated to 230°F (110°C) or higher Sentry DCCP Reboiler...
-
Page 10: Operation
ƒ If droplets of hot boiling water are seen venting from the condensate drain, either reduce the temperature setpoint or increase the flow rate. ƒ Adjustments should be within the specified ranges for flow rate and temperature Sentry Equipment Corp... - Page 11 Use the up or down arrow key to select the desired temperature unit of measure: C for Celsius scale or F for Fahrenheit scale. d. Press the gray infinity key for two (2) seconds to return to the Home Page. Sentry DCCP Reboiler...
- Page 12 ƒ Check the resin column and note whether the color change has passed the line on the column. If the color change has passed the line, replace the column or recharge with new resin. Replacing and Cleaning Analyzer Electrodes Establish a routine schedule to replace and/or clean analyzer electrodes (refer to manufacturer’s literature). Sentry Equipment Corp...
-
Page 13: Spare Parts List
Spare Parts List Tag No. Qty. Description Part No. Heater, 120V, CSA Version 4-05935A HTR-1 Heater, 240V 4-05935B FU-1 Fuse, Controller, 1/2A 4-01235F Fuse, Heater 120V, 15A 4-01235E FU-2 Fuse, Heater 240V, 8A 4-01235Z TIC-1 Controller, Temperature 6-03012N Sentry DCCP Reboiler... -
Page 14: Drawings
Drawings Figure 3. DCCP General Arrangement (standard) 0 [0] Sample Inlet Condensate Drain Cooling Water Inlet Cooling Water Outlet Sample Outlet 17 1/2 [444] without analyzers 24 1/2 [622] with analyzers Sentry Equipment Corp... - Page 15 2 19 9/16 496 SAMPLE COOLER RESIN COLUMN FLOW INDICATING CONTROL VALVE HEATER 4 7/8 123 (BEHIND HEAT SHIELD) DCCP FLAT PLATE W/ REGENERATIVE DCCP FLAT PLATE W/ REGENERATIVE COOLING WATER COOLING WATER (ANALYZERS NOT SHOWN) (ANALYZERS NOT SHOWN) Sentry DCCP Reboiler...
- Page 16 Figure 5. Electrical Wiring Diagram Sentry Equipment Corp...
-
Page 17: Standard Warranty
To view the full warranty, go to www.sentry-equip.com/warranty. Customer Support With proven sampling expertise since 1924, Sentry products and services provide business operations the critical insights to optimize process control and product quality. We deliver true representative sampling and analysis techniques to customers around the globe, empowering them to accurately monitor and measure processes for improved production effi ciency, output, and safety. - Page 18 This page is intentionally left blank. Sentry Equipment Corp...
- Page 19 This page is intentionally left blank. Sentry DCCP Reboiler...
- Page 20 Serving customers in more than 50 countries across six continents worldwide. sentry-equip.com 966 Blue Ribbon Circle North, Oconomowoc, WI 53066 U.S.A. | +1-262-567-7256 | support@sentry-equip.com...