Using The Magicstomp; Turn On The Amplifier And Play; Try Out Some Of The Other Patches - Yamaha MAgicstomp Guitar Effects Professor Owner's Manual

Using the MAGICSTOMP

The MAGICSTOMP comes loaded with a variety of effect patches (programmed effects).
First, give some of the presets a try and see what's available.

■ Turn on the amplifier and play

You'll hear the currently selected patch.
Use the MAGICSTOMP's VOLUME knob to adjust the MAGICSTOMP's output volume.

■ Try out some of the other patches

The MAGICSTOMP has a total of 198 patches. 99 of those are User Patches (U01 – U99) to which
you can save (overwrite) data of patches that you have created. The other 99 are Preset Patches
(P01 – P99) which can not be overwritten with new data. You can however, edit the Preset Patches
and save them in the User Patch section.
* When shipped from the factory, the MAGICSTOMP's User Patch section contains the same data as found in the
Preset Patches.
● Two ways to select patches
When the MAGICSTOMP is shipped from the factory, its [UP/DOWN MODE] is already set for the
patch selection mode. In this mode, just press the + switch to move to the next greater patch number,
and press the – switch to move to the next lesser patch number. Hold either switch down and the
patch numbers will quickly cycle up or down in order.
In this mode, the ON/OFF switch is used to switch the patch (effect) on or off.
Pressing the – switch decreases
the patch number by 1
U01
U98
U99
P01
P97
12
Patch No.
Patch Name
U99¤MAGICSTOMP0
ó‡GAINfiMSTRáTONE
P98
P99
Effect ON
U01¤DIST
ó‡GAINfiMSTRáTONE
U01¤DIST
ó‡BAL0fiSTERáVOL
U03
U02
U01¤DIST
ó
Pressing the + switch increases
the patch number by 1
P99
P02
P01
U99
U04
Effect OFF
EFFECT OFF