Troubleshooting - Russell Hobbs QUIET SUPER STEAM PRO Quick Start Manual

4. Unscrew the plug underneath the cover and lift the plug and filter assembly out of the base (Fig B).
5. Remove the filter from the plug by twisting it (fig C).
6. Rinse the filter under a tap to remove any deposits. Use a soft brush if necessary.
7. Replace the filter onto the plug and twist it until it locks.
8. Refit the plug and filter assembly into the base and tighten it firmly. Close the cover.
9. Plug in your steam generator.
10. Reset the warning light by pressing and holding the anti-scale warning light/reset button (a) for 3
seconds until the light goes out.
11. Once the appliance is ready, pull the steam trigger until the steam is being produced. This will prime
the system.
Important: Using the appliance without cleaning the filter can cause a reduction in the generated steam
output and damage the appliance. The guarantee will not cover damage caused to the appliance by not
cleaning the anti- scale filter when required.
Do not clean the anti-scale filter in a dishwasher. Wash by hand only using a soft bristled brush if necessary.

TROUBLESHOOTING

Your steam generator is programed to check itself when it is switched on. If a problem is detected and the
unit is not able to operate correctly, the steam trigger will stop working, the thermostat light will flash and
the unit will beep continuously. If this should happen, stop using your steam generator.
Light Flashing
Anti-scale warning light (a) flashing
Thermostat light and on/off button flashing
Low water light (d) flashing
Thermostat light flashing
Thermostat light flashing
Beeps Status
3 Anti-scale filter needs cleaning
- Auto shut off activated
2 Water tank empty
- Iron is heating up
Continuous Internal error. Discontinue use.
7