Ryobi RY4CSS Manual

WARNING:
This Engine Starting Procedure is not a substitute for
reading the operator's manual. To reduce the risk of injury, user must
read and understand operator's manual before using this product.
Cold Engine:
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole.
1
Later uses: Check engine lubricant level and add lubricant if needed.
LUBRICANT
Carefully pour fuel into the tank. Avoid spillage.
2
Immediately replace fuel cap and hand tighten.
1 GALLON
Wipe up any fuel spillage.
GAS
PRIME
3
10x
slowly.
SET
4 CHOKE lever to "FULL CHOKE"
position. Squeeze throttle trigger fully through
step 6.
5 With throttle fully engaged,
and rope sharply until engine runs. (Max 3 times)
• If 60°F or lower, continue to pull starter grip and
rope until engine runs.
HALF
• If 60°F or above, set CHOKE lever to "HALF
CHOKE
CHOKE" and pull starter grip and rope until
engine runs.
6
RUN
After 10 seconds,
RUN position.
Warm Engine:
Press the PRIMER BULB 10 times
slowly. Set choke lever to RUN. Pull
RUN
starter grip and rope until the engine
10x
runs.
To Stop:
DEPRESS the "STOP" switch to the STOP position
995000057
9-9-16 (REV:01)
press the PRIMER BULB 10 times
PULL
starter grip
SET
CHOKE lever to the
ENGINE STARTING PROCEDURE
NOTICE
Do not use E15 or E85 fuel in
this product. It is a violation of
federal law and will damage
the unit and void your warranty. Only use unleaded
gasoline containing up to 10% ethanol.
1
Go to www.ryobitools.com and register your new tool on-line. For any questions about
operating or maintaining your product, call the Ryobi
fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips
are also available in your operator's manual. For additional registration instruction, refer
to operator's manual.
5
4 6
5
2
4
Help Line! Your Product has been
®
RUN
HALF
CHOKE
FULL
CHOKE
3