Sanyo TH 1015M Instruction Manual page 4

IMPORTANT INFORMATION
ABOUT RECHARGEABLE BATTERIES
It will take 3 to 5 recharges to bring your batteries to full power. This is a general
characteristic of rechargeable batteries.
The correct procedure to charge the batteries is as follows:
1)Turn the power switch to off on the handset.
2) Place handset on the base unit and charge for 8 to 10 hours.
3) Take handset off of the base unit.
4) Turn power on until the battery low light appears.
5) Repeat procedure 3 times for optimum performance.
From then on, simply charge as needed.
If you store your telephone for long periods (unused), it is best to charge the batteries
at least once every 90 days of non-use in order to maintain a charged condition and
avoid battery failure. If this is not done, the initial charging instructions must be
followed to rejuvenate your telephone batteries. If it is not followed, you may find the
telephone will only work for a short period. Following the original charging instructions
you should be able to bring the batteries back to full power.
While each system is impossible to predict, you should be able to recharge your batteries
from 500 to as many as 900 times. When your batteries fail, replacement batteries
are available from the SANYO PARTS DEPARTMENT.
CONTROL OPERATION AND FUNCTION
HANDSET
TALK/STANDBY/OFF SWITCH
This is the main on-off power switch. It must be placed in the STANDBY position
(slide) for an incoming call to activate the beeper and for the system to operate when
making a call and this switch must be placed in the TALK position to answer an
incoming call and to place an outgoing call.
TALK INDICATOR
Indicates when the TALK/STANDBY/OFF Switch in the TALK position.
REDIAL
By pressing the redial key on the bottom of the keyboard, you may automatically
redial last number called.
VOLUME HI/LOW SWITCH
Listening level is locating on the side of the Handset. In a noisy area, set to HI position
to overcome surrounding noises.
BATTERY LOW INDICATOR
Lights up when the batteries are low and need to be charged.
KEYBOARD
The keyboard is used just like the buttons on a standard Touch calling phone. After
the telescopic antenna is fully extended and the TALK/STANDBY/OFF switch is
placed in the TALK position, you will hear a dial tone. Then simply select the number
you wish to call. If an error is made in dialing or you receive a busy signal, place the
TALK/STANDBY/OFF switch to the STANDBY position and then back to the TALK
position to receive a new dial tone and redial.
-3 -