Advertisement
• With a remaining battery capacity of approx. 20 %, the portable charger can have the
following charging times:
With 2 A USB charger via the Micro USB input
- Item No. / Model 1005BTF (10050 mAh): up to approx. 8 hours
- Item No. / Model 1006BTF (20100 mAh): up to approx. 12 hours
With 3 A USB charger via the USB Type-C™ input
- Item No. / Model 1005BTF (10050 mAh): up to approx. 6 hours
- Item No. / Model 1006BTF (20100 mAh): up to approx. 9 hours
• Check the model you have purchased. While charging, the current battery level will be
indicated by a percentage flashing on the display.
• Once the battery is fully charged, the battery level indicator will be lit steadily.
• Disconnect the connected cables. The battery level indicator will go off after approx. 10 seconds.
c) Charging a mobile device
• You can charge the portable charger and your mobile devices at the same time.
It is not recommended to charge the portable charger and connected mobile devices
at the same time as the battery of the portable charger will be constantly discharging
in this case. Accordingly, it takes longer to charge the internal battery of the portable
charger.
• Connect the USB-A connector of the USB charging cable to the USB-A output (4). If your
mobile device has a USB Type-C™ port, you can use the USB Type-C™ connector (not
included) to plug a charging cable into the USB Type-C™ input/output (3). Products with a
USB Type-C™ port normally enable a higher charging current and can therefore be charged
faster than those with a Micro USB port.
The maximum charging current (3 A) is distributed to the USB outputs when both
outputs are used. Therefore, take note of the amount of charging current required by
your mobile device.
• While charging, the battery level of the portable charger will be indicated by the steadily lit
remaining capacity.
• Disconnect the USB charging cable from the connected product and the portable charger
to stop or interrupt charging. The battery level indicator will go off after approx. 10 seconds.
Care and cleaning
• Disconnect the product from connected products and from the power supply before every
cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as
they can cause damage to the housing and malfunctioning.
• Clean the product with a dry, fibre-free cloth.
• When cleaning, be sure to avoid contact with water or other liquids.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
Input voltage/current ..................... Micro USB input 5 V/DC, 2 A
USB Type-C™ input 5 V/DC, 3 A
Output voltage/current .................. USB-A output 5 V/DC, max. 2.4 A
USB Type-C™ output 5 V/DC, max. 3 A
All USB outputs combined max. 3 A
Operating conditions ..................... 0 to +35 °C, <75 % RH
Storage conditions ........................ 0 to +35 °C, <75 % RH
Item No. / Model No. 1005BTF
Internal battery .............................. Li-Ion / 10050 mAh
Dimensions (L x W x H) ................ 115 x 63 x 22 mm
Weight .......................................... 194 g
Item No. / Model No. 1006BTF
Internal battery .............................. Li-Ion / 20100 mAh
Dimensions (L x W x H) ................ 160 x 81 x 22 mm
Weight .......................................... 364 g
Distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
These operating instructions are a publication by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower
2, Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems require
the prior written approval by the editor. Reprinting, also in part, is prohibited. These operating instructions represent the
technical status at the time of printing.
Copyright 2018 by CEI Conrad Electronic International (HK) Limited
*1005_1006BTF_1594596_1599557_v1_0518_02_hk_m_en
Advertisement
