Minute Repeater; Water Resistance - Patek Philippe 5316 Manual

Minute Repeater

The strike sequence of the minute repeater
must be allowed to end completely before it
is activated again.
Caution: Never actuate the winding crown
as long as the repeater is working and for
30 seconds thereafter. Doing so could cause
damage to the repeating mechanism which
would not be covered by the warranty.
To activate the striking mechanism, push the slide
(8) all the way up. Now release it completely – do
not pull it down! Two small hammers will now
strike the hours, quarter-hours, and minutes on
two gongs of low and high pitch.
If the watch was set aside unwound for an exten-
ded period of time, the minute repeater might
not indicate the correct time because the oil may
have thickened at some points inside the mecha-
nism. This is absolutely normal and has no nega-
tive consequences. The striking mechanism will
function correctly again within one or two hours
after the watch has been rewound.
Recommendations

wATER RESISTANCE

Although your watch is equipped with a water-
resistant crown and a sealed case back, it is not
protected at all against the ingress of moisture
because of the slot for the minute repeater slide.
Therefore, exercise care to ensure that liquid does
not come into contact with your watch.
SERvICE
We recommend that you have your watch ser-
viced at least once every three to five years. For
this purpose, we suggest you take it to an Au-
thorized Patek Philippe Retailer who will send
it to our Geneva manufacture, the only location
authorized to service watches with minute re-
peaters. You can then be assured that your watch
will be inspected and overhauled by a qualified
master watchmaker at Patek Philippe headquar-
ters in Geneva.
The master watchmaker will completely disas-
semble the movement and then inspect, clean,
and lubricate all the individual parts prior to re-
assembly. All functions of the watch will also be
tested in detail and the escapement regulated if
necessary. Finally, its rate accuracy will be moni-
tored and precision-adjusted for a further period
of at least two weeks.
The case and the buckle will be polished as per
your instructions and your watch will be returned
to you in mint condition. The entire process will
take several weeks because each watch must un-
dergo a complete series of tests to fulfill the strict
quality criteria of Patek Philippe.
If you have any questions regarding the main-
tenance of your watch, contact the Authorized
Patek Philippe Retailer nearest you or our Inter-
national Customer Service department in Geneva,
or visit www.patek.com.