Coolant - Yamaha FJR1300AT(C) Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
To change the final gear oil
1. Place an oil pan under the final
gear case to collect the used oil.
2. Remove the oil filler bolt and drain
bolt to drain the oil from the final
gear case.
3. Install the final gear oil drain bolt,
and then tighten it to the specified
torque.
Tightening torque:
6
Final gear oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
4. Add the recommended final gear
oil to the brim of the filler hole.
Recommended final gear oil:
Shaft drive gear oil (Part No.: 9079E-
SH001-00)
Oil quantity:
0.20 L (0.21 US qt) (0.18 Imp.qt)
5. Install the oil filler bolt, and then
tighten it to the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
6. Check the final gear case for oil
leakage. If oil is leaking, check for
the cause.
6-15

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
The coolant level should be checked as
follows before each ride. In addition,
the coolant must be changed at the in-
tervals specified in the periodic mainte-
nance and lubrication chart.
1. Place the vehicle on the center-
stand.
NOTE:
G
The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
G Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Check the coolant level in the cool-
ant reservoir.
EAU20070
EAU20261