INSTRUCTIONS
INSTALLATION
1
Thoroughly clean your phone
screen with microfiber cloth,
removing all dust and fingerprints.
3
2
1
5 Find 3 notches along underside of faceplate. Align notches
along top edge of case. Press down to engage notches
with case.
8 Slide thumbs down faceplate, purging air from inside case
and establishing flush contact between protective film and
phone screen.
10 Ensure all edges are flush.
2 Inspect underside of faceplate
and remove any debris.
3 Slide phone into case bottom
end first, maintaining alignment
of foam pad.
6 Snap bottom corner of the
faceplate onto the main case
body until you hear an audible
"click". Repeat on other corner.
9 Snap bottom hinges on until
you hear an audible "click".
OPTIONAL
Thread the lanyard through holes on
botton right corner. Loop back through
and pull tight.
Thule.com/ThuleAtmosX5installation
4 Use thumbs to snap opposite
side of phone into case.
7 Snap side hinge on until you
hear an audible "click".
Repeat on other side.
1