Confirming Operation; Check The Indicators And Settings - Bose Link AR1 Owner's Manual

C
ONFIRMING OPERATION

Check the indicators and settings

Before you use this addition to the audio link, you may want to
check some of the indicators and settings that make your
expansion products work together smoothly.
The Status LED
On the connection panel of both the transmitter and the
receiver, the Status LED indicates how the two units are
communicating, as shown in the table below.
Status
LED
On the
transmitter
On the
receiver
On the receiver, a blinking or solid orange light indicates a
communications problem. Repositioning the transmitter or
receiver, or both, may resolve the problem and cause both
LEDs to change to solid green. For further information, refer to
"Troubleshooting" on page 9.
Your Bose
• Room code
• House code
For information on these house code and room code settings
and how to change them, refer to the owner's guide that came
with your remote.
Note:
which must be identical to each other, do NOT need to match
house codes on the remote or LIFESTYLE
8
Blinking Solid
Green Green
Searching Receiver
for receiver located
Searching for Solid signal
transmitter received
® link expansion room remote control
If you have more than one LIFESTYLE
room set up, make sure the remote used in each one has a
unique room code.
The house code setting on the remote must match the set-
ting on your LIFESTYLE
have changed the system house code due to interference
with another Bose LIFESTYLE
Setup codes for the AL8 transmitter and AR1 receiver,
Français Español
Blinking Solid
Orange Orange
Not Powered on,
applicable no communication
Weak signal Weak or no signal
received received
® system expansion
®
system. This is an issue only if you
®
system.
®
system.
English