Yamaha CLAVINOVA C L P - 3 8 Owner's Manual page 89

Setting the chorus on/off
[ChorusOnOff]
You can set the [CHORUS] button on or off for each
voice. When you select a voice, the chorus on/off setting
for the voice automatically changes according to this
parameter.
TIP
Even if this parameter is turned on, the chorus effect is disabled if the
ChorusSend parameter is set to 0.
See the procedure on page 80.
A
Main
ChorusOnOff
C
Setting range:
On/Off
Selecting the DSP type*
[DSP Type (DSP)]
You can select other effects (than reverb and chorus).
See the procedure on page 80.
A
Main
DSP Type
C
Setting range:
DelayLCR...............Delay applied at left, center, and right
positions.
DelayLR .................Delay applied at left and right positions.
Echo.......................Echo-like delay
CrossDelay ............Left and right delays are crossed.
Symphonic .............Adds a rich and deep acoustic effect.
Rotary.....................Adds the vibrato effect of a rotary speaker.
Tremolo ..................The volume level changes in rapid cycles.
VibeRotor ...............The vibrato effect of a vibraphone.
AutoPan .................The sound pans left to right and back and
forth.
Phaser....................The phase changes periodically, swelling
the sound.
AutoWah.................The center frequency of the wah filter
changes periodically.
SoundBoard ...........Simulates the reverberation of a piano
soundboard.
Off ..........................No effect.
B
Set?-->
NO YES
Off
D
B
Set?-->
NO YES
DelayLCR
D
Detailed settings for the voices [VOICE SETTING]
Setting the speed of the vibraphone
vibrato effect*
[VibeRotorSpeed]
TERMINOLOGY
Rotor= The rotating portion of an electrical device etc.
This will be displayed only if VibeRotor is selected for the
DSP Type parameter explained above.
This sets the speed of the vibrato effect that is applied
when you have selected Vibraphone and are using the
VibeRotor pedal.
See the procedure on page 80.
A
Main
VibeRotorSpeed
C
Setting range:
1 – 10
Turning the vibraphone vibrato effect
on/off*
[VibeRotorOnOff (RotorOnOff)]
This will be displayed only if VibeRotor is selected for the
DSP Type parameter explained above.
It turns on/off the vibrato effect that is applied when you
use the VibeRotor pedal.
See the procedure on page 80.
A
Main
VibeRotorOnOff
C
Setting range:
On/Off
B
Set?-->
NO YES
6
D
B
Set?-->
NO YES
On
D
89
CLP-380 Owner's Manual