Download Print this page

Fellowes Powershred 70S Instructions Manual page 2

Hide thumbs Also See for Powershred 70S:

Advertisement

Available languages

Available languages

A.
B.
C.
D.
E.
F.
CAPABILITIES
Will shred: Paper, plastic credit cards, CD/DVDs, staples and small paper clips
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard,
large paper clips, laminates or plastic other than noted above
Paper shred size:
Strip Cut ................................................................................................................. 5.8mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
set to off or unplug when not in use.
DO NOT use aerosol products, petroleum based or aerosol lubricants on or near
shredder. DO NOT USE "CANNED AIR" OR "AIR DUSTERS" ON SHREDDER. Vapors
Do not place near or over heat source or water.
BASIC SHREDDING OPERATION
Continuous operation:
10-12-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
Plug in and put
disconnect power
10-12-minutes will trigger
20-minute cool down period.
switch in ON (I) position
1
G.
H.
KEY
I.
J.
A. Indicator lights
PAPER OR CD/CARD
1
2
Press Auto-On (I)
B. Paper entry
1. Overheat (red)
C. See safety instructions
2. Bin Open (red)
D. Card/CD entry
3. Remove Paper (red)
E. Window
F. Pull-out bin
G. Disconnect power switch
1. OFF
2. ON
Maximum:
Sheets per pass ........................................................................................................... 14*
Cards/CDs per pass ....................................................................................................... 1*
Paper entry width .................................................................................................. 230mm
* A4 (70g), paper at 220-240V/50/60 Hz, 1Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Recommended daily usage rates: 600 sheets per day;
25 cards; 10 CDs.
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
voltage and amperage designated on the label. The grounded outlet or socket
transformers, or extension cords should not be used with this product.
3
4
14
14
Check paper amount
Feed paper straight into
paper entry and release
H. Safety lock
I. Auto-On (green)
J. Control switch
I
1. Auto-On
O 2. OFF
R 3. Reverse
14 sheets per pass.
5
or
14
Feed into card/CD
entry and release
ENGLISH
Model 70S
6
When finished
shredding set
to OFF (O)

Advertisement

loading