Table of Contents
Advertisement
Connecting two broadband modems
a
Procedure
1.
Ensure the XC-DPG503 and the DSL/Cable modem are powered OFF.
Leave the modem or modems connected to their data line.
2.
Connect the Broadband modem(s) to the XC-DPG503.
If using only one (1) Broadband modem, connect it to the "WAN 1" port.
3.
Use standard LAN cables to connect PCs to the LAN ports on the XC-DPG503.
Both 10BaseT and 100BaseT connections can be used simultaneously.
Use a standard CAT-5 Ethernet cable to connect any port on the XC-DPG503 to
a standard port on another hub. Any LAN port on the will automatically act as an
"Uplink" port when required.
4.
Power Up
Power on the Cable or DSL modem(s).
Connect the supplied power adapter to the XC-DPG503 and power up.
5.
Check the LEDs
The Power LED should be ON.
The WAN – Link LED should be ON when the corresponding WAN port is
connected toa broadband modem.
For each PC connected to the LAN ports, the corresponding LAN LED (either 10 or
100) should be ON.
Figure 4. Installation Diagram for XC-DPG503
DC 5V
WAN2
Reset
LAN Ports
Broadband Modem
Local Area Network
WAN1
Broadband Modem
12
Advertisement
Table of Contents
