Table of Contents
Advertisement
6.1
SECURING THE PRINTER
The main body of the printer and platen block must be secured to the outer case separately with screws.
6.1.1
Printer Mounting Method
Secure the printer with a hole E and 2 pawls (C, D), as shown below. Holes A and B are used for
positioning the body of the printer. Design bosses for positioning holes A and B precisely in the outer
case.
See "CHAPTER 7 APPEARANCE AND DIMENSIONS" for locations and dimensions.
Recommended Screws
The recommended mounting screws are as follows:
1)
Screw: JIS B1111 cross-recessed pan head machine screw: M2.0
2)
Screw: Cross-recessed pan head tapping screw to secure resinated material: nominal size 2 mm
CHAPTER
HOUSING DESIGN GUIDE
Figure 6-1 How to Secure the Printer
6-1
6
Unit: mm
Advertisement
Table of Contents
